ProSYS User Guide 33
Chapter 4: Omitting a Zone
[1] [1] [CODE] [Zone No.]
When an intrusion zone is not secured, the keypad's Ready LED will
not light (unless there is a fault in the system), nor can the system be
readily set. If programmed by engineer, you can omit zones in order to
set a partition even if a zone within that partition is open/not secured.
You may want to omit a zone when access is needed to one zone in an
otherwise protected area, or to cause the system to temporarily
circumvent a zone containing damaged wiring until repairs can be
made.
WARNING:
An omitted zone may reduce the system's security capability.
Before performing the following procedure, identify the faulty zone(s) as
follows:
Enter the view zone status option in location [3][4] and then scroll down
with the down arrow key to view all "not ready" zones. The LCD only
displays "not ready" zones that belong to the user code that was
entered.
To change a zone's omit status:
1)
THE JONESES
THE JONESES
05:42 DEC 16 TUE
05:42 DEC 16 TUE
THE JONESES
THE JONESES
05:42 DEC 16 TUE
05:42 DEC 16 TUE
From the Normal Operation mode, enter
your code and press
. The Omit LED
is illuminated.
NOTE:
If you make a mistake when entering your user code, the keypad will produce
three short beeps. Re-enter the sequence correctly.
2)
OMT Z=001 (CL)N
OMT Z=001 (CL)N
ZONE 001
ZONE 001
OMT Z=001 (CL)N
OMT Z=001 (CL)N
ZONE 001
ZONE 001
Enter the zone number.
Entering the zone number a second time un-omits it (toggle
action).
An additional zone(s) can be omitted at the same time by
adding its number to the sequence. For example, to omit zones
2 and 13 using code 1234, enter:
1-2-3-4
02 13
To Next Page
Loading...
