ProSYS User Guide 21
NOTE:
If defined by your engineer press for quick setting
NOTE:
If you make a mistake, the keypad produces three short beeps. If so, press
quickly and re-enter the above sequence correctly.
3)
THE JONESES
THE JONESES
SET: EXIT = 0:45
SET: EXIT = 0:45
THE JONESES
THE JONESES
SET: EXIT = 0:45
SET: EXIT = 0:45
All persons are to exit via the authorized
exit route.
A continuous sound will sound from the
keypad’s buzzer and internal sounder. The
Set LED flashes while the system counts
down the Exit Delay time period (shown in
the bottom right of the LCD). The exit tone
will change if any detectors are violated
during exit time.
The system is set when the exit time has
expired, on activation of the Final Exit zone
or when the Exit Terminator button is
pressed.
THE JONESES
THE JONESES
SET
SET
THE JONESES
THE JONESES
SET
SET
The Set LED will light and a confirmation
message will appear for the time defined
by your installation company. After that
time the display will return to the partition
status display. The strobe will activate for
10 seconds, indicating a successful set of
the system (if defined).
NOTE:
During the exit time, a zone outside the exit route can prevent setting of the
system or can trigger an alarm from the keypad and the internal speaker (as
defined by your installation company).
To Next Page
Loading...
