Risco ProSYS 128 - Page 54

54 ProSYS User Guide
6)
KEY A CUSTOM:
KEY A CUSTOM:
KEY A CUSTOM:
KEY A CUSTOM:
Use the numerical keys or the
key to
enter a series of characters representing
your required keys, as described on page
55. Each character you enter is displayed in
the second line of the LCD.
7)
KEY A CUSTOM
KEY A CUSTOM
1234a12a
1234a12a
KEY A CUSTOM
KEY A CUSTOM
1234a12a
1234a12a
When you have finished entering the series
of characters, ensure that the cursor is
placed in the field after the last character in
the series, and press [A] (or the function
key you selected in step 4) again. The
series of characters is saved and assigned
to the selected function key.
For example:
The following series of characters should
be entered to program the macro
Fault Reset:
¾3#(customer code)#S#¾¾
NOTE:
When entering characters, ensure that the cursor is placed after the last
character. Otherwise, the last character you defined and everything after it will
be erased, and the Function key will not perform the required function.
8)
ACCESS CODE:
ACCESS CODE:
1) UPDATE CODES
1) UPDATE CODES
ACCESS CODE:
ACCESS CODE:
1) UPDATE CODES
1) UPDATE CODES
If required, select an additional Function
key to program and repeat the above
procedure.