70 ProSYS User Guide
Bell Circuit Failure or
Fire Loop Fault or
Line Fault
Three rapid beeps
at 10-second
intervals (2,3)
No Sound No Sound
Chime Sound
2 second buzzer
beep (4)
NOTES:
1. Based on decisions made at the time your alarm system was installed this
sound may be enabled or disabled
2. Keypad beeps may be disabled at the user's discretion, see buzzer On/Off
on page 63.
3. Press for two seconds to stop the fault beeps.
4. Any intrusion zone, if selected for the Chime feature, will, when violated
during the unset period, cause the keypad to annunciate the event. The
chime can also be disabled when not required.
To Next Page
Loading...
