Risco WisDom - Page 48

48 WisDom User Manual
¾ To program a Function key:
1)
From the User Functions menu, select [8] Function
Key.
2)
Enter the Grand Master code followed by
.
3)
The Choose Key menu lists the 3 Function keys. Select
the Function key that you want to program.
4)
Press [1] for 2 seconds (Or the Function key you
selected in the previous step)
5)
Use the numerical keys or the
key to enter a
series of characters representing your required keys,
as described on page 49. Each character you enter is
displayed in the second line of the LCD.
6)
MACRO A:
#11234a#21234a
MACRO A:
#11234a#21234a
After entering the series of
characters, ensure that the cursor is
placed in the field after the last
character in the series otherwise, the
last character you defined and
everything after it will be erased, and
the Function key will not perform the
required function. Press [1] for 2
seconds again (or the Function key
you selected in step 4). The series of
characters is saved and assigned to
the selected Function key.
7)
If required, select an additional Function key to program
and repeat the above procedure.