Risco WisDom - Page 51

WisDom User Manual
51
Quick
Key
Function Description
2 Follow Me
(FM)
This option allows to program 2 options regarding the
follow Me number:
1) Define FM: Define up to 4 Follow Me telephone
numbers. In case of an alarm the system will generate a
call to the designated number. For more information refer
to page 49
2) Terminate FM: If Follow-Me Phone Number(s) were
chosen, their operation can be terminated. Use this
function when an alarm has been tripped and there is no
need to utilize the Follow-Me phone call.
3 Alarm
Receiving
Center
(ARC)
Control
Allows user control of operation relating to operation
with the ARC:
1) Initiate call: By initiating a call to your alarm company,
this allows them to perform a remote programming
operation on your system
2) Hand over: Similar in intent to Initiate Call (above).
Hand Over allows your alarm company to call you and,
during the call, "hand over" to them the control of your
security system
3) Enable U/D: Each time this function is enabled, your
alarm company may subsequently gain a single remote
access to your system to make any required
programming changes.
4) Cancel report: Sends a "Cancel Alarm" report
message to the Central Station. This function is used if
the alarm was activated by mistake.
5) Void rep. Prog: For engineer use only! Some
protocols have a report code to the monitoring station for
entering and exiting the engineer programming. To avoid
the entering report and save time, this function
postpones the report for two minutes during which the
engineer can enter the programming menu and no report
will be made.
4 Delete
Remote
Message
Deletes a message that has been sent to the LCD from
the Upload/Download software.