105
Advisory Messages
Requesting Supply and Disposal
Message Description and Action Reference
An Ink cartridge is empty.
Replace it with a new one.
A Master roll is depleted.
Install a new one.
The Master disposal box is full of used masters.
Pull out the box and discard used masters.
Paper is depleted and/or not loaded in the Paper feed tray.
Load paper in the Paper feed tray.
p.96
p.98
p.100
p.20
No Ink
Replace Ink Cartridge
No Master
Replace Master Roll
Empty Master Disposal Box
Add Paper
Action
Action
Action
Action
Informing Troubles in Master-Making Area
Message Description and Action Reference
Master has not been properly loaded on the Print Cylinder
(Drum).
qOpen the Front cover and pull out the Print
Cylinder (Drum). Then remove the master on the
Print Cylinder (Drum) and return the Print
Cylinder (Drum) into the original position.
wOpen the Master making unit and wind the
Master roll. Then reset master in place. After
closing the Master making unit, resume operation
from master-making.
Master has misfed.
Open the Master making unit and wind the
Master roll. Then reset master in place. Press the
START key to resume operation.
Master was not cut correctly.
qOpen the Front cover and pull out the Print
Cylinder (Drum). Then remove the master on the
Print Cylinder (Drum) and return the Print
Cylinder (Drum) into the original position.
wOpen the Master making unit and wind the
Master roll. Then reset master in place. After
closing the Master making unit, resume operation
from master-making.
The cutter did not operate in master cutting.
Open the Master making unit and wind the Master
roll. Then close the Master making unit.
p.74, 98
p.98
p.74, 98
p.98
Master was Not Loaded
on Print Cylinder (Drum) Correctly
Pull Out Print Cylinder (Drum) and
Remove Master on it
Master Mis-Feed
Rewind Master Roll and
Reset Master in Place
Pull Out Print Cylinder (Drum) and
Remove Master on it
!!System Error!!
Rewind Master Roll and
Close Master Making Unit
Action
Action
Action
Action
To Next Page
Loading...
