112
Paper sticks to the surface of the Print Cylinder (Drum).
• Use recommended printing paper.
☞ p.18
• Lower the vertical print position with the VERTICAL PRINT POSITION
Adjustment key.
☞ p.39
• Replace the original in the reverse direction and restart printing from the
beginning (master-making).
Paper cannot feed well.
• Paper slips.
• Set the Paper feed pressure adjustment lever to "CARD".
☞ p.20
• Change the Paper feed mode according to the type of the paper in use.
☞ p.20
Printed copies are not ejected well.
• The Paper Ejection Wings are not set correctly.
Position the Paper Ejection Wing Adjustment Levers according to the size and
thickness of the printing paper.
☞ p.22
Action
Action
Action
Troubleshooting Tips
The unit does not start even when the power switch is pressed.
The "Close Front Cover" message appears even when the Front cover is closed.
There is no image on copies.
The unwanted background of an original is picked up on copies.
Copies are incomplete; some images are missing or unclear.
Printed copies are half or three quarter blank in the Multi-Up printing.
Printed images are excessively faint or blurred.
Vertical blank lines are found on printed copies.
The back of finished copies are smudged with ink.
Paper sticks to the surface of the Print Cylinder (Drum).
Paper cannot feed well.
110
110
110
110
110
111
111
111
111
112
112
TT
roubleshooting Tips
This section describes how to take care of problems
that may arise with your RISOGRAPH.
Check the following "Tips List" and the related items
before calling your authorized service representative.
109
To Next Page
Loading...
