24
Safety Guides
- Handling and Operation
Operation Environment
Important!
• Operate the unit under the following appropriate ambient environment conditions.
- Temperature range: 59°F to 86°F (15°C to 30°C)
-Humidity range: 40% to 70% (noncondensing)
This section describes the precautions to be observed when handling your
RISOGRAPH. Read this section before operating your RISOGRAPH.
Handling Precautions
WARNING
• Do not insert or drop any metallic material or flammable substance into this unit through any opening.
Otherwise, a fire or an electric shock might occur.
• Do not remove the covers. Otherwise, you might be electrically shocked by the high-voltage parts inside.
• Do not disassemble or rebuild this unit by yourself. Otherwise, a fire or an electric shock might occur.
• If this unit gets uncomfortably hot, smokes or smells bad, immediately turn off the power, unplug the
electrical (power) cord and contact your service representative because a fire or an electric shock might
occur.
• If something drops inside this unit, turn off the power switch first, then unplug the electrical (power) cord
and contact your service representative. If you continue using it, a fire or an electric shock might occur.
• Never stick your hands or fingers in the openings around the Paper Feed Tray and the Paper Receiving
Tray during operation.
• Keep loose clothing or long hair away from moving parts to avoid becoming entangled.
• Before cleaning any part of this unit, turn off the power.
Caution
• Do not open any covers or move this unit during operation.
• Unplug the electrical (power) cord, if you do not use this unit for a long time.
Important!
• Do not unplug the electrical (power) cord or turn off the power during operation.
• Be sure to open and close any cover gently.
• Do not place heavy objects on or apply shocks to this unit.
• This unit has precision parts and driving parts inside. Do not handle this unit in other ways than
described in this guide.
• Contact your local service representative before moving this unit.
Caution - Handling of Ink
• If ink gets into your eyes, flush it out immediately with plenty of water.
• If ink comes into contact with your skin, wash it off thoroughly using soap.
• Allow plenty of ventilation during printing.
• If you feel unwell during use, seek medical advice.
• Only use the ink for printing purposes.
• Keep the ink out of the reach of children.
Important! - Materials Not to Be Printed
Remember not to infringe copyrights or violate laws when using the equipment, even during personal use.
Consult your local authorities for further details. In general, use discretion and common sense.
!
!
!
21
Adding or Replacing Paper
If you want to add paper or use paper of different size,
lower the Paper Feed Tray so that you can load the paper
easily.
When the Feed Tray Descent Button is pressed lightly, the
Paper Feed Tray lowers to the bottom. When you keep on
pressing it on the other hand, the tray stops immediately
when you release it.
Important!
Do not mix different paper sizes in the Paper Feed Tray.
Setting Up the Paper Receiving Tray
1
Open the Paper Receiving Tray.
2
Raise and slide the Receiving Tray
Paper Guides to fit the paper
width.
Holding the Receiving Tray Paper Guide
Adjustment Knob, slide the guides.
• For thick paper, set the guides a little
wider than the actual paper width.
• When you change the horizontal print
position, adjust the position of the
Receiving Tray Paper Guides as well.
3
Adjust the Paper Arrangers.
Select the best combination of Paper Arranger
settings, referring to the following instruction.
= How to Set Paper Arrangers =
• Ordinary paper
Open all four Paper
Arrangers.
Open two Paper Arrangers
on the more heavily printed
side.
Open two Paper Arrangers
closest to the machine.
• Ordinary paper with
images lopsided on page
• Thick paper
NOTE
NOTE
To Next Page
Loading...
