C2 User Manual, Release 1.0.0
4. Check the wiring on your main electronics board. Every so often, the ribbon cable coming from the main
electronics board can come loose. You will need to first take the inner panel out, located inside the printer below
the bed, to get to the inside of the printer. Once that is out, you will see two electronics boards. We want to
look at the one on the left, which is black. On the back right of the black electronics board, there is a ribbon
cable plugged in. Make sure this ribbon cable is seated all the way down into its plug to ensure there is a proper
connection.
56 Chapter 4. Troubleshooting
To Next Page
Loading...
