ORBIT 16
When wrapping very wide products, guide
supports must be moved after having loosened
the handles (B).
5.3. PRESSURE UNIT
ADJUSTMENT
Height position
When processing round and high
products, move the pressure units in top
position:
1. Disassemble the support by removing
screws (B).
2. Put them back in the desired position
using the special holes and (B) screws.
Caution - Warning
Between top pressure units and product
there must always be space.
When in bottom position, the pressure
units must not touch the conveyor but
must keep a distance of 10/15 mm.
Check the position by operating the
corresponding solenoid valve manually
with a screwdriver lo lower the pressure.
Important
See the wiring diagram to identify the
solenoid valve to operate.
To Next Page
Loading...
