ORBIT 16
4.5.2.CARRIERS INSTALLATION
1. Remove packing from conveyors
2. Remove the screws that fasten the
conveyors.
3. Connect the conveyor and support it as
to prevent damage to the conveying
belt.
4. Lift the conveyor and screw the adjusting
legs to it.
5. Connect the infeed carrier to the base
and tighten the screws (C).
Note
Remember that the adhesive arrows on
conveyors indicate the normal operating
direction of the same.
Caution - Warning
During operation, be careful to not
damage the clamp unit.
To Next Page
Loading...
