Robopac ORBIT 16 - 6.9.1. PUTTING THE ROTATING RING IN PHASE

ORBIT 16
‒ The machine must be cleaned and in order.
‒ Compressed air supply must be open and pressure adjusted to 6bar.
‒ The film reel must be sufficiently full to guarantee operations (See "Coil replacement").
‒ The coating must be attached to the side hook.
‒ The rotating ring must be in phase (see “Timing of the rotating ring”).
‒ Check the position of the “Door opening request” selector switch.
It should be turned so as to allow the machine to start.
‒ Turn main switch in pos. I.
T
he machine is read
y
to
p
erform the o
p
eration.
|
Note
At first start up after a change of operation, it is necessary to perform some trial cycles to check the quality of
the wrapping operation.
6.9.1.PUTTING THE ROTATING RING IN PHASE
T
he machine does not operate and does not block the film in the clamp if the rotating ring is no
t
in phase.
With the rotating ring in any position, pressing the Reset button will align the ring instead of starting the
operation.
Work can then be started.
75/95