ORBIT 16
Every 2000
hours
Axial and radial
(rotating ring
retaining
wheels).
General
inspection
Check for wear
and, if
necessary,
replace Contact
the Servicing
Department.
-
Every 2000
hours
Axial and radial
(rotating ring
retaining
wheels).
General
inspection
Axial and radial
rotating ring
retaining wheels
position
adjustment.
See “Rotating
ring retaining
wheels” -
“Position
adjustment”.
Every 2000
hours
Conveyors General
inspection
Check for wear
and, if
necessary,
replace Contact
the Servicing
Department.
-
Every 2000
hours
Conveyors General
inspection
Tension
adjustment
see “Infeed
carrier, outfeed
carrier - Belt
adjustment”.
Every 2000
hours
Safety devices Efficiency
control
Replace the
damaged
components.
-
Every 2000
hours
Reducer filter Condensation
control
Condensation
discharging
See “Condensate
drainage”
Every 2000
hours
Reducer filter cleanliness Clean with a
blast of air and
alcohol.
See “cleaning air
filter”.
Every 5000
hours
Cutting blade Efficiency
control
Replacement See “Film cutting
blade
replacement”.
7.3. CONDENSATE DISCHARGE
Proceed as indicated:
1. Close the tap (A) and control the level of
condensation in the container (B).
2. Unscrew, if necessary, the valve (C) to
empty condensation.
3. Push the valve (C) up until all
condensation is removed.
4. Tighten the valve (C).
To Next Page
Loading...
