ORBIT 16
M) Product winding end time (tail)
This is the time that determines the
winding end position relative to the end
of the product.
Important
To rename the recipe, you must touch
key (A).
When the keypad is displayed, carry out
the indications given in paragraph 6.4.
N) Key to enable/disable coating breakage
control.
Press to enable the function, press again
to disable it.
O) Key to enable/disable the outlet pressure
roller descent advance.
Press to enable the function when
machining short products.
Press again to disable the function.
P) Key to enable/disable heat sealing.
Press to enable the function, press again
to disable it.
Note
The key (P) is available only if the
optional welder is installed.
Q) Sealing time
It is the welder closing time.
Note
The key (Q) is available only if the
welding function has been enabled by
pressing the key (P).
To Next Page
Loading...
