Robopac ORBIT 16 - Page 89

ORBIT 16
E67 “BLADE NOT IN POSITION” ALARM
Cause:
- Clamp cylinder magnetic sensors not properly working
Remedy:
- Check and replace the sensor if necessary
E68 “STOPPER NOT IN POSITION” ALARM
Cause:
- Clamp cylinder magnetic sensors not properly working
Remedy:
- Check and replace the sensor if necessary
E69 “WELDER NOT IN POSITION” ALARM
Cause:
- Clamp cylinder magnetic sensors not properly working
Remedy:
- Check and replace the sensor if necessary
89/95