Rockwell Automation 1769-IF4 User Manual

Publication 1769-UM002B-EN-P - July 2005
Overview 1-3
Hardware Features
The modules contain removable terminal blocks. The 1769-IF4 and -IF8
channels can be wired as either single-ended or differential inputs. The
1769-OF2, -OF8C, and -OF8V channels are single-ended only. Module
configuration is normally done via the controller’s programming software. In
addition, some controllers support configuration via the user program. In
either case, the module configuration is stored in the memory of the controller.
Refer to your controller’s user manual for more information.
Figure 1.2 1769-OF2, -OF8C, -OF8V and -IF4 Analog Module’s Hardware Features
Table 1.2 1769-OF2, -OF8C, -OF8V, and -IF4 Feature Descriptions
Item Description
1 bus lever (with locking function)
2a upper panel mounting tab
2b lower panel mounting tab
3 module status LEDs
4 module door with terminal identification label
5a movable bus connector with female pins
5b stationary bus connector with male pins
6 nameplate label
7a upper tongue-and-groove slots
7b lower tongue-and-groove slots
8a upper DIN rail latch
8b lower DIN rail latch
9 write-on label for user identification tags
10 removable terminal block (RTB) with finger-safe cover
10a RTB upper retaining screw
10b RTB lower retaining screw
10a
10b
4
10
2b
3
2a
1
5
a
9
5
b
6
7a
7b
8b
7b
8a
7a
1769-OF8C
DANGER
Do Not Remove RTB Under Power
Unless Area is Non-Hazardous
Ensure Adjacent
Bus Lever is Unlatched/Latched
Before/After
Removing/Inserting Module
dc
NEUT
I out 2 +
I out 3 +
I out 4 +
I out 5 +
I out 6 +
I out 7 +
+24V dc
I out 1 +
I out 0 +
ANGL
Com
ANLG
Com
ANLG
Com
ANLG
Com
ANLG
Com
ANLG
Com
ANLG
Com
ANLG
Com
OK
Analog
OK
Analog

Rockwell Automation 1769-IF4 Specifications

General

Brand	Rockwell Automation
Model	1769-IF4
Category	I/O Systems
Language	English