Rockwell Automation Allen-Bradley PowerFlex 20P - Install the Communication Adapter and EMI Shield

Rockwell Automation Publication 20P-TG002B-EN-P - February 2018 47
Part Replacement Procedures Chapter 3
7. Remove the three screws that secure the EMI shield to the standoffs on
the control board and remove the EMI shield.
8. Remove the three standoffs from the control board.
Install the Communication Adapter and EMI Shield
Install the communication adapter and EMI shield in reverse order of removal.
7
Tightening torque:
1.0 N
•m (8.9 lb•in)
8
Tightening torque:
1.0 N
•m (8.9 lb•in)