Rockwell Automation ArmorStart Bulletin 280G User Manual

4-40 Bulletin 284G Programmable Parameters for Sensorless Vector Controllers
Brake Voltage
Sets the frequency where brake voltage is applied when Parameter 184 (Boost
Select) = 0 Custom V/Hz and Parameter 225 (Torque Perf Mode) = 0V/Hz.
Parameter Number 186
Related Parameters
131, 132, 134, 135, 184, 185,
187, 188, 225
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 1.1%
Minimum Value 0.0%
Maximum Value 100.0%
Default Value 25.0%
Brake Frequency
Sets the frequency where brake frequency is applied when Parameter 184 (Boost
Select) = 0 Custom V/Hz and Parameter 225 (Torque Perf Mode) = 0V/Hz.
Parameter Number 187
Related Parameters
131, 132, 134, 135, 184, 185,
186, 188, 225
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.1 Hz
Minimum Value 0.0 Hz
Maximum Value 400.0 Hz
Default Value 15.0 Hz
Maximum Voltage
Sets the highest voltage the drive will output.
Parameter Number 188
Related Parameters 104, 185, 186, 187
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 1V AC
Minimum Value 20V AC
Maximum Value Drive Rated Volts
Default Value Drive Rated Volts
Current Limit 1
Maximum output current allowed before current limiting occurs
Parameter Number 189
Related Parameters 133, 218
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.1 A
Minimum Value 0.1 A
Maximum Value Drive rated amps X 1.8
Default Value Drive rated amps X 1.5

Rockwell Automation ArmorStart Bulletin 280G Specifications

General

Brand	Rockwell Automation
Model	ArmorStart Bulletin 280G
Category	Controller
Language	English