2-14 Installation and Wiring
Terminal Designations for Bulletins
280G, 281G, and 284G
As shown in the next figure, the ArmorStart Distributed Motor Controller
contains terminals for power, control, and ground wiring. Access can be
gained by removing the terminal access cover plate.
Figure 2.10 ArmorStart Power, Control and Terminals
Table 2.2 Power, Control, and Ground Terminal Designations
Terminal Designations No. of Poles Description
A1 (+) 2 Control Power Input
A2 (-) 2 Control Power Common
PE 2 Ground
1/L1 2 Line Power Phase A
3/L3 2 Line Power Phase B
5/L5 2 Line Power Phase C
To Next Page
Loading...
