EasyManuals Logo

Rockwell Automation ArmorStart Bulletin 280G User Manual

Rockwell Automation ArmorStart Bulletin 280G
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #239 background imageLoading...
Page #239 background image
Bulletin 280G/281G CIP Information B-15
Discrete Output Point Object —
CLASS CODE 0x0009
The following class attributes are supported for the Discrete Output
Point Object:
Table B.39 Discrete Output Point Object Class Attributes
Four instances of the Discrete Output Point Object are supported. The
following table summarizes the DOP instances:
Table B.40 Discrete Output Point Object Instance Attributes
All instances contain the following attributes.
For DOP instances 1 and 2, attributes 113 and 114 have “Get” only access, and their values are
always 0.
The following common services are implemented for the Discrete
Output Point Object:
Table B.41 Discrete Output Object Common Services
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 1
2 Get Max Instance UINT 2
Instance ID Name
Alternate
Mapping
Description
1 Run Fwd Output 0029 – 01 – 03
Run Forward output. For all starter
types, this output is hard wired from
the ArmorStart CPU to the actuator
2 Run Rev Output 0029 – 01 – 04
Run Reverse output. For all starter
types, this output is hard wired from
the ArmorStart CPU to the actuator
3 Reserved none
4 Reserved none
Attribute ID Access Rule Name Data Type Value
3 Get Value BOOL 0=OFF, 1=ON
5 Get/Set Fault Action BOOL 0=Fault Value attribute, 1=Hold Last State
6 Get/Set Fault Value BOOL 0=OFF, 1=ON
7 Get/Set Idle Action BOOL 0=Fault Value attribute, 1=Hold Last State
8 Get/Set Idle Value BOOL 0=OFF, 1=ON
113 Get/Set " Pr Fault Action BOOL 0=Pr Fault Value attribute, 1=Ignore
114 Get/Set " Pr Fault Value BOOL 0=OFF, 1=ON
115 Get/Set Force Enable BOOL 0=Disable, 1=Enable
116 Get/Set Force Value BOOL 0=OFF, 1=ON
Service
Code
Implemented for:
Service
Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rockwell Automation ArmorStart Bulletin 280G and is the answer not in the manual?

Rockwell Automation ArmorStart Bulletin 280G Specifications

General IconGeneral
BrandRockwell Automation
ModelArmorStart Bulletin 280G
CategoryController
LanguageEnglish

Related product manuals