Rockwell Automation ArmorStart Bulletin 280G - Acknowledge Handler Object - CLASS CODE 0 X002 B

Bulletin 280G/281G CIP Information B-23
The following common services are implemented for the Control
Supervisor Object:
Table B.53 Control Supervisor Object Common Services
Acknowledge Handler Object —
CLASS CODE 0x002b
No class attributes are supported for the Acknowledge Handler
Object.
A single instance (instance 1) of the Acknowledge Handler Object is
supported. The following instance attributes are supported:
Table B.54 Acknowledge Handler Instance Attributes
The following common services are implemented for the
Acknowledge Handler Object:
Table B.55 Acknowledge Handler Common Services
Service Code
Implemented for:
Service Name
Class Instance
0x0E No Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single
Attribute ID Access Rule Name Data Type Value
1 Get/Set Acknowledge Timer UINT milliseconds
2 Get Retry Limit USINT 1
3Get
COS Producing Connection
Instance
UINT 4
Service Code
Implemented for:
Service Name
Class Instance
0x0E No Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single