Bulletin 284G CIP Information C-23
The following State Transition Diagram is used in Auto State for
Unbound DOP Instances 1, 2, 9, and 10
Figure C.3 Auto State for Unbound DOP Instances 1, 2, 9, and 10
Auto Init
Idle
Ready
Run
DNet Fault
Protection Fault
Receive Idle
Protection Fault
DNet Fault
DNet Fault
DNet
Fault
Protection Fault
DNet
Idle
Connection Transitions to Established
Connection
Transitions to Established
Protection Fault
Receive Data
Protection Fault
DNet Fault
Protection Fault Reset
To Next Page
Loading...
