Rockwell Automation ArmorStart Bulletin 280G - Page 63

Bulletin 280G/281G Programmable Parameters 3-9
➊ Bulletin 280G products.
➋ Bulletin 281G products.
Produced I/O Size
This parameter reflects the
produced I/O data size in bytes.
Parameter Number 18
Access Rule GET
Data Type USINT
Group DeviceNet
Units —
Minimum Value 0
Maximum Value 8
Default Value 2
Starter COS Mask
This parameter allows the
installer to define the change-of-
state conditions that will result in
a change-of-state message
being produced
Parameter Number 19
Access Rule GET/SET
Data Type WORD
Group DeviceNet
Units —
Minimum Value 0
Maximum Value 16383
Default Value
16149
➊
16157 ➋
Bit
Function
13 12 11 10 9 8 7 6 5 4 3 2 1 0
————————————— X Tripped
———————————— X — Warning
—————————— X —— Running Fwd
—————————— X ——— Running Rev
————————— X ———— Ready
———————— X ————— NET Ctl Status
——————— X —————— 140M On
—————— X ——————— Reserved
————— X ———————— Input 0
———— X ————————— Input 1
——— X —————————— Input 2
—— X ——————————— Input 3
— X ———————————— Input 4
X ————————————— Input 5