Chapter 5 Operating
2104.6536.72 - 5.26 - E-1
vated, no alarms/traps are sent when the transmitter is in local mode. You can activate/
deactivate this function using Inhibit Status in the SNMP > General menu window.
The MIBs have the naming convention RS-XX8000-<TV/Radio Standard>-<Standby
Concept/Option>-MIB. An example is RS-XX8000-ATV-TX-MIB for signal transmitters
for analog TV.
Examples of MIBs and contents:
2. Save the required ZIP file to your PC.
3. Load the following MIBs:
a) RS-COMMON-MIB
b) RS-XX8000-COMMON-MIB
c) MIB of the standby concept or option
A detailed description of the MIBs, the information that they contain and the associated op-
tions is given below.
MIB Description
RS-COMMON-MIB Contains general Rohde&Schwarz definitions
RS-XX8000-COM-
MON-MIB
Contains definitions which all XX8000 transmitters fulfill (e.g. type
plate, configuration)
RS-XX8000-DVB-TX-
MIB
Contains definitions for DVB single transmitters, passive exciter
standby, active and passive output-stage standby
RS-XX8000-DVB-
NP1-MIB
Contains definitions for DVB n+1 systems
RS-XX8000-DVB-
NTX-MIB
Contains definitions that an R&S NetCCU800 provides as access for
n different, independent DVB transmitters
RS-XX8000-DVB-TX-
REC-MIB
Contains definitions for the optional DVB receiver in a transmitter
RS-XX8000-DVB-
NP1-REC-MIB
Contains definitions for the optional DVB receiver(s) in an n+1 sys-
tem
RS-XX8000-FM-TX-
MIB
Contains definitions for FM single transmitters with passive exciter
standby and active and passive output-stage standby
RS-XX8000-FM-NP1-
MIB
Contains definitions for FM n+1 systems
RS-XX8000-ATV-TX-
MIB
Contains definitions for analog TV single transmitters with passive
exciter standby and active and passive output-stage standby
RS-XX8000-ATV-
NP1-MIB
Contains definitions for analog TV n+1 systems
To Next Page
Loading...
