Rohde & Schwarz SCV8000E/R - R&S Vh8 X01 C1 Base Amplifier - Rear Panel; X1 (MAINS): Power Feed (AC); X2 (POWER OUT): RF Output; X66 (GPS) - GPS Antenna;Option SX801 B13: Antenna Input for GPS Receiver

Chapter 9 Annex
2104.6536.72 - 9.7 - E-1
1.2.2.11 X66 (GPS) – GPS Antenna/Option SX801B13: Antenna Input for GPS
Receiver
SMA, female
1.2.3 R&S VH8x01C1 Base Amplifier – Rear Panel
1.2.3.1 X1 (MAINS): Power Feed (AC)
85 V to 265 V AC
M3E+6X+PE connector from Schaltbau
Note The instrument must first be connected to the safety ground. The line filter is built into the
Power Adaptor Board.
1.2.3.2 X2 (POWER OUT): RF Output
N, female
Signal name Direction Value range Contact Comment
GPS ANTENNA Input Minimum level:
-128 dBm
X66.1 50 
GND Bidirect. 0 V X66.2
Signal
name
Direction Value range Contact Remarks
L Input U
nom
= 100 V to 240 V AC (±10 %);
50 Hz to 60 Hz (±5 %); cos  0.9;
I  10 A (230 V)
I  21 A (110 V)
I  26 A (90 V, base amplifier)
I  27 A (90 V, extended amplifier)
X1.2 AC supply
N Input 0 V X1.5 AC supply
PE Input 0 V X1.PE AC supply