Chapter 5 Operating
2104.6536.72 - 5.73 - E-1
Fig. 20 The Nonlinear operating window
5.4.1 Main Function
The Corr > On/Off switch can be used to turn the entire nonlinear precorrection on or off.
5.4.2 Nonlinear Precorrection
For manual precorrection, you model the amplitude and phase characteristics in the draw-
ing level and then write them to the precorrection memory.
Functions, area 1
The following settings are possible:
Correction Amplitude > On/Off: Switches the amplitude precorrection on or off.
Correction Amplitude Clear: Clears the data in the precorrector for the nonlinear am-
plitude precorrection; you will be asked if you are sure you want to do this.
Curve Data Amplitude Write: Writes the nonlinear precorrector with the amplitude
characteristic modeled in the drawing level.
To Next Page
Loading...
