Chapter 8 Service
2104.6536.72 - 8.2 - E-1
For easy connection of replacement instruments and devices, proceed as follows:
1. Determine the connector number on the yellow cable sleeve.
2. Find the same number on the instrument to be connected (connector or connection di-
agram).
3. Insert the plug connector into the corresponding female connector.
1.2.1 Single Transmitter with One Amplifier
Fig. 1 Example: Cabling the R&S SCV8301E
1) Power feed
2) ASI input
3) RF signal from exciter to input of base amplifier
4) CAN bus
5) Transmitter output
To Next Page
Loading...
