Chapter 5 Operating
2104.6536.72 - 5.8 - E-1
Entering data via the Text Editor
Fig. 9 Entering values
1) Entry line
2) Selectable characters
3) Command line
1. Use the cursor keys to move the cursor to the entry position.
2. To enter characters, move to the required character using the cursor keys and then con-
firm with the OK key.
The selected character appears in the entry line at the cursor position.
or
To delete characters, set the cursor after the character you wish to delete, then use the
cursor keys to select Del char and confirm with the OK key.
The character to the left of the cursor position is deleted.
3. To save changes (current entry in the entry line), select Enter text using the cursor keys
and then confirm with the OK key.
This closes the editor, stores the changes and displays them in the menu window.
Note Enter text will work only if the instrument is set to "local" and authorization to change
parameters is held. Otherwise the only way to exit from the editor is to use Discard.
or
To close the editor without saving the changes, select Discard using the cursor keys and
then confirm with the OK key.
The editor closes and you return to the menu window. Your changes are not saved.
4. Press the HOME key to finish menu editing.
Note If you select the Fix Editor command in the context menu (see section "Context Menu"),
the editor will remain open until you close it by pressing the Back key.
1.2.3.5 Context Menu
The context menu contains function- and content-oriented commands which can be applied
to the currently displayed menu.
The context menu can be called from any position using the MENU key.
To Next Page
Loading...
