Chapter 3 Installation
2104.6536.72 - 3.2 - E-1
2 Connecting the Cables
2.1 Overview of the Connections
2.1.1 Connections on the Exciter
Fig. 1 Connections on rear panel of R&S SX801
Rear panel connectors
WARNING!
Always make sure that the power supply is disconnected before connecting any devices.
This will prevent injuries and damage to the devices.
No.
Labeling
(Name)
Type Connector
X1 Low-temperature con-
nector
Power feed (VAC or VDC)
X2 REMOTE
(Ethernet remote)
RJ45, female connector,
8-pin
Network connection for remote
access; preset address at X2:
– IP address: 192.168.58.253
– Subnet mask: 255.255.255.0
X3 LOCAL
(Ethernet local)
RJ45, female connector,
8-pin
Connector to a PC for local operation;
preset address at X3:
– IP address: 192.168.57.253
– Subnet mask: 255.255.255.0
X4 RS485 D-Sub, female, 9-pin RS485 serial connector
To Next Page
Loading...
