Rohde & Schwarz SCV8000E/R - Page 61

Chapter 3 Installation
2104.6536.72 - 3.3 - E-1
X5 AMP D-Sub, male connector,
15-pin
Amplifier control unit
X6 TX
(Tx control)
D-Sub, female, 9-pin RF loop and CAN bus; connector for
parallel remote control interface or
N+1 system; power reduction on the
external amplifier
X8 PAR I/O D-Sub, female, 9-pin Parallel connector for signaling con-
tacts and control inputs
X9 RS232 D-Sub, male, 9-pin RS232 serial connector
X20 TS1
ETI1
BNC, female, 75 
(DAB: also > 10 k)
– DTV: Transport stream input 1
(with hierarchy: HP stream)
– DAB/T-DMB: Transport stream
input 1
X21 TS2
ETI2
BNC, female, 75 
(DAB: also > 10 k)
– DTV: Transport stream input 2
(with hierarchy: LP stream)
– DAB/T-DMB: Transport stream
input 2
X22 VF BNC, female, 75  ATV: Analog video input
X23 PPS IN
(1PPS EXT IN)
BNC, female, 50  Input for seconds pulse from external
reference
X24 REF OUT BNC, female, 50  TV/DAB monitor interface: Monitoring
output for internal 1 pps or 10 MHz
signal
X25 AUDIO D-Sub, male connector,
15-pin
ATV: Analog audio AF input
X26 BTSC
(ATV: BTSC;
DAB: ETI OUT)
BNC, female, 75  – ATV: Analog audio input to BTSC
standard (M, N)
– DAB: Optional output of ETI signal
on exciter input or downstream of
delay memory
X27 NICAM
(ATV: NICAM Data;
DAB: COFDM
SYNC)
BNC, female, 50  – ATV: Digital data input for NICAM
728
– DAB: DAB monitor interface: Start
of COFDM frame on exciter output
X50 FAN1 Molex, male connector
(4-contact)
Fan supply 1
X52 FAN2 Molex, male connector
(4-contact)
Fan supply 2
X60 RF OUT SMA female Output from internal amplifier
X64 REF IN BNC, female, 50  Reference input, 5 MHz or 10 MHz,
-5 dBm to 20 dBm or TTL
No.
Labeling
(Name)
Type Connector