Chapter 5 Operating
2104.6536.72 - 5.14 - E-1
Checking and adapting the settings for Java Applets
1. Select the Security tab.
2. For the Internet zone select the Custom Level option.
3. In the tree structure go to Scripting > Scripting of Java applets and select the Enable
option.
Installing Java (Sun) JRE if necessary; checking and adapting the settings
1. Select the Advanced tab.
2. Check whether the entry Java (Sun) JRE ... is present and enabled.
3. If necessary, download and install (standard installation) the Java Runtime Environment
from the Sun website "www.java.com".
4. Then select the Internet Explorer's Advanced tab again and check whether the software
is installed and enabled.
1.3.2 Login
Note To be able to operate the transmitter via a PC that is connected locally, the R&S SX801
must be set for local operation (press the LOCAL key so that the associated LED lights up).
1. Start the browser on your PC or network client.
2. Enter the IP address of the Ethernet interface for the R&S SX801 that you are using to
make contact.
The login screen appears.
3. Enter the desired identification together with the password (see table) and click the
Logon button (R&S).
The web GUI opening screen appears.
Note Logging on in this way starts a new session on the instrument web server.
Factory-default user information
User ID Authorization Password
Configuration Allows you to set basic transmitter parameters; e.g. setup 1234
To Next Page
Loading...
