Chapter 5 Operating
2104.6536.72 - 5.13 - E-1
For remote control connect the remote monitoring network by RJ45 cable to the X2 (Eth-
ernet Remote) port on the R&S SX801.
Setting IP addresses at the exciter
For communication between the transmitter and a local PC or a remote network client, the
IP address of the Ethernet interface that is used in the R&S SX801 must be in the IP subnet
of the PC or the remote monitoring network.
You can directly enter the address data needed for communication via the R&S SX801 dis-
play.
Note Alternatively, you can also adapt the IP address of your PC to the subnet of the exciter un-
der Windows and retain the factory setting for the local network interface X30 (IP address
= 192.168.57.253, network mask = 255.255.255.0). In this case, configure the network ad-
dress of your PC to, for example, 192.168.57.100/255.255.255.0.
1. On the display of the R&S SX801, select the System > Ethernet menu.
Fig. 12 Enter the IP address data.
2. Enter the address for the X3 local interface under Loc.IP Address and Loc.Subnet
mask.
3. Enter the address for the X2 remote-control interface under Rem.IP Address and
Rem.Subnet mask.
Note If any changes were made to the network settings, the R&S SX801 must be restarted.
Before you can operate the exciter via your browser, the following conditions must be sat-
isfied:
– Javascript must be enabled
– "Java Platform Standard Edition" must be installed and activated.
The next section uses Microsoft Internet Explorer 6 to explain how you can check whether
these conditions have been met or what changes you need to make.
Note Please note that the settings described here need not match your current browser version
one hundred percent.
All necessary changes and settings can be found in the Tools > Internet Options menu on
your Internet Explorer.
ATTENTION!
Please note that the modified settings described here may adversely affect the security of
your Internet connections.
To Next Page
Loading...
