Chapter 5 Operating
2104.6536.72 - 5.65 - E-1
Fig. 16 Basic structure of an operating field
Each operating field consists of graphics areas and functional areas.
The graphics areas are used to display the set characteristics. Here, you can interactively
modify, reset or redraw the characteristics. You can also set a default characteristic. Using
a contextual menu, you can access additional functions as well as a navigator for fine ad-
justment.
There are two graphics areas per operating field. The upper graphics area 1 is used to dis-
play amplitude precorrections. The lower graphics area 2 is used to display phase or group
delay precorrections.
The functional area contains buttons, input field, checkboxes and message windows that
are used to manage the precorrection process. It is divided into the following areas:
Main functions
This area contains functions that apply to all of the displayed precorrection (ON/OFF,
choice of manual or automatic mode).
Function area 1
This area contains functions referring to the curve in graphics area 1.
Function area 2
This area contains functions referring to the curve in graphics area 2.
Note In certain operating windows, some of these areas will not be present.
To Next Page
Loading...
