Chapter 6 Maintenance
2104.6536.72 - 6.4 - E-1
6. In the Device List, select the device to be updated by enabling the check box.
7. Click Install to start the update.
After performing the update, a corresponding message will be output in the output line
at the bottom left of the window. The transmitter is automatically rebooted.
Note If the update is interrupted before it has been completed (the message "Copying/Install-
ing ... %" stops before 100 % level is reached), abort the update by clicking Cancel and
then restart the R&S Software Distributor.
To Next Page
Loading...
