Using knobs or buttons to select an
editing page
By operating a front panel knob or button, you can
directly access the screen page for that parameter, and
edit it. For example, if you rotate the [CUTOFF] knob,
the display will automatically change to the Cutoff
Frequency setting page, and you can edit the setting
while viewing the values for each tone.
* This method cannot be used to edit parameters for which
there is no knob or button on the front panel.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Parameters which are assigned to a knob
The parameters which can be adjusted by a knob are
determined by the status of the [ENVELOPE/LFO1/
EFFECTS] indicator and the [FILTER/AMP/PITCH]
indicator.
fig.5-5-1
When the “ENVELOPE” indicator and “FILTER”
indicator are lit
fig.5-5-2TEXT
1: Filter Envelope Attack Time (p. 63)
2: Filter Envelope Decay Time (p. 63)
3: Filter Envelope Sustain Level (p. 63)
4: Filter Envelope Release Time (p. 63)
5: Filter Envelope Depth (p. 64)
6: Cutoff Frequency (p. 62)
7: Resonance (p. 63)
When the “ENVELOPE” indicator and “AMP” indi-
cator are lit
fig.5-5-3TEXT
1: Amplifier Envelope Attack Time (p. 68)
2: Amplifier Envelope Decay Time (p. 68)
3: Amplifier Envelope Sustain Level (p. 68)
4: Amplifier Envelope Release Time (p. 68)
5: – No parameter is assigned.
6: Tone Level (p. 67)
7: Tone Pan (p. 67)
When the “ENVELOPE” indicator and “PITCH”
indicator are lit
fig.5-5-4TEXT
1: Pitch Envelope Attack Time (p. 58)
2: Pitch Envelope Decay Time (p. 58)
3: Pitch Envelope Sustain Level (p. 58)
4: Pitch Envelope Release Time (p. 58)
5: Pitch Envelope Depth (p. 59)
6: Portamento Time (p. 78)
7: Fine Tune (p. 57)
When the “LFO1” indicator is lit
fig.5-5-5TEXT
1: LFO1 Rate (p. 72)
2: LFO1 Fade Time (p. 74)
3: LFO1 Pitch Depth (p. 73)
4: LFO1 Filter Depth (p. 73)
5: LFO1 Amplifier Depth (p. 73)
6, 7: Determined by the [FILTER/AMP/PITCH] status
To Next Page
Loading...
