fig.5-42 (#MC fig.3-41)
Tone Level
This is the setting page for “Adjusting the volume of
each tone (Tone Level)” (p. 67).
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Bias
The Bias parameters specify how the key position will
affect the Tone Level. This can be used to simulate the
way in which the volume of an acoustic instrument
changes according to the location (pitch) of the note.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Bias Dir (Bias Direction)
Select the keyboard area(s) that will be affected above
and/or below the specified Bias Point.
Available settings:
LWR: The volume will be modified for the keyboard
area below the note specified as the Bias Point.
UPR: The volume will be modified for the keyboard
area above the note specified as the Bias Point.
L&U: The volume will be modified symmetrically
toward the left and right of the note specified
as the Bias Point.
ALL: The volume will be modified linearly from the
note specified as the Bias Point.
Bias Point
Specifies the key relative to which the volume will be
modified.
Range: C-1–G9
Bias Level
Adjusts the slope of the volume change that will occur
in the direction specified by Bias Direction.
Range: -100–+100
With positive (+) settings, the slope of volume change
will increase in the positive (+) direction. With nega-
tive (-) settings, the slope of volume change will
increase in the negative (-) direction.
* Even with positive (+) settings of this parameter, the vol-
ume cannot exceed the maximum level.
fig.5-43 (=MC fig.3-42)
To Next Page
Loading...
