[The operation has been stopped to prevent the print heads from drying out.
Turn the printer off.]
The print heads were forced to standby position to prevent them from drying out
Operation cannot be continued. Switch the sub power off, and then back on. Opening the front cover while output is in progress
causes an emergency stop. Never allow the print heads to remain in this state.
[Motor error]
A motor error occurred
Operation cannot be continued. By following the messages displayed in the Utility window, remove the media, close the front cover,
and then hold down the [POWER] key to switch the sub power off.
This error may be caused by factors including the following:
• The media has been set incorrectly
• The media has jammed.
• An operation that pulled the media with excessive force was performed.
Eliminate the case of the error before switching the sub power on, and then reload the media.
[Waste cartridge is estimated to be full]
Operation was stopped because the waste cartridge is full.
Operation cannot be resumed without correcting this error. Replace the waste cartridge with a new one by following the message
displayed in the Utility window. If a new waste cartridge is not available for immediate replacement, switch the main power off.
[Temperature error]
The temperature of the location where the machine is installed has risen above or fallen below the ambient
temperature at which the machine can operate.
Operation cannot be continued. Turn off the sub power. Bring the installed location to a temperature at which operation is possible
(20 to 32°C [68 to 90°F]), allow the machine to come to room temperature, and then turn on the power.
[Cover open error.]
Output was stopped because the front cover or maintenance cover is open.
Close the cover, and then start output again.
[Sheet setup error]
Setup of the media has failed.
Load the media correctly.
RELATED LINKS
・ P. 20Loading Media
Error Messages
Handling Messages and Error Messages 111
To Next Page
Loading...
