This section describes operations when printing only.
Refer to Cutting / Printing and Cutting(P. 40), Performing Printing and Cutting Separately(P. 47).
Step 1: Loading Media
Loading Roll Media
Procedure
1. Move the left media guide to the left edge.
(1) Push the loading lever (
) backward.
(2) Move the left media guide ( ) to the left.
2. Attach the media flange ( ) to one end of the media bar ( ).
Insert the side of the media bar with a hole ( ) into the media flange. When loading roll media
with a 3-inch paper tube inner diameter, attach the media flange with ( ) on the inside. When
loading roll media with a 2-inch paper tube inner diameter, attach the media flange with ( ) on
the inside.
3. Insert the mounting pin ( ) into the media flange and the media bar, and then secure them with the pin
( ).
Printing
20 Basic Operations
To Next Page
Loading...
