Output Quality Problems
Printed results are coarse or contain horizontal stripes..........................................87
Do the print heads show nozzle clogging? ....................................................87
Have you carried out[Calibrate Sheet Feeding] ? ..........................................87
Have you carried out [Bidirectional adjustment] ? ........................................87
Is the temperature of the room too low?.....................................................87
Is the printer installed in a level and stable location? .....................................87
Is the printer installed in a location out of direct sunlight? ...............................87
Is the media loaded and set up correctly? ...................................................87
Colors are unstable or uneven........................................................................89
Did you shake the ink cartridges gently before installing them? .........................89
Is the media wrinkled? ..........................................................................89
Is the printer installed in a level and stable location? .....................................89
Is the printer being used in a location subject to severe changes in the oper-
ating environment? ........................................................................89
The media becomes soiled when printed...........................................................90
Are the print heads dirty?.......................................................................90
Cutting is misaligned or skewed......................................................................91
Is the media loaded and set up correctly? ...................................................91
Are the settings for the cutting conditions appropriate? ..................................91
Is the length of output too long?...............................................................91
Are you using media that exhibits large expansion and contraction? ....................91
The printed surface is damaged when cutting .....................................................92
Does the tip of the blade holder cap scrap the printed surface? .........................92
86
Output Quality Problems
To Next Page
Loading...
