[Data error]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check whether or not there is an error in the data. Check for a problem with the connector cable
or the computer, and then start output again.
[Ink has run out.]
Output was stopped because ink has run out.
On the [Ink] tab of the Utility window, check the color of the cartridge that has run out of ink, and then replace the ink cartridge
with a new one.
RELATED LINKS
・ P. 60Checking for Remaining Ink
・ P. 61How to Replace the Ink Cartridge
[Pinch lever was returned.]
Output was stopped because the loading lever was pushed backward while output was in progress.
Pushing the loading lever backward cancels the setup of the media, so output is stopped. Reload the media.
[No sheet is present.]
Output was attempted but failed because no media was present.
Load media.
[Printing cannot continue because the end of the sheet was detected. Printing
will be canceled.]
Printing was stopped because the trailing edge of the media was detected.
When the trailing edge of the media is detected, output is canceled.Load new media.
[ServiceCall No**]
An unrecoverable error occurred, or part replacement that must be performed by a service technician is
required
Note the number displayed on the display screen, and then switch off the main power. After you switch off the power, inform your
authorized dealer of the number that appeared on the display screen.
[Ink Cartridge error : *** ink cartridge ]
An ink cartridge that cannot be used was installed
Remove the ink cartridge of the indicated color to clear the error. Use an ink cartridge of the specified type. ("***" is the color of
the ink.)
Error Messages
112 Handling Messages and Error Messages
To Next Page