The following four output methods are available for this machine.
Printing (Only) Printing using ink. It is also called "Printing Only" to distinguish from "Printing and Cutting."
Cutting (Only)
Cutting using a blade such as for seal die cutting. It is also called "Cutting Only" to distinguish from
"Printing and Cutting."
Printing and Cutting
Printing method in which printing is followed by cutting. If output data that contains both printing
and cutting information is sent to the printer, the cutting operation starts after printing finishes.
Crop-Cut
Output method using "Crop Marks" to align the printing and cutting results. If you are printing on
the media, removing it so it can be laminated, and then reloading the media in the machine to cut
it, use the crop marks to align the media.
Important Points During Use
Use the machine periodically
We recommend using the machine at least once a week. If left unused for a long period of time, the ink
may settle, resulting in unstable discharge (and nozzle clogging). Any dry ink will need to be discharged.
Four Different Output Methods
Basic Information 15
To Next Page
Loading...
