Step 4: Correcting the Media Feed
Procedure
1. Open the Utility window.
P. 10Opening the Utility Window/Exiting Utility
2. Click [Calibrate Sheet Feeding].
3. Click [Test Print].
A test pattern is printed.
4. Follow the on-screen instructions and enter the value for [New Value].
The current correction value (A) is that of the figure indicated by "
." Select the value to make
the gap (B) and overlap (C) between the upper/lower squares smallest. In the case of the following
figure, select "−1.05%." When you cannot choose between two sequential numbers, specify a value
that is between them.
Printing
Basic Operations 31
To Next Page
Loading...
