Manual Cleaning Method
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the heads from drying out, finish this procedure in 10 minutes or less. A warning beep sounds after 10
minutes.
• Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may
damage the heads. If you use up the cleaning sticks, contact your authorized dealer.
• Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks may reduce
print quality.
• Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the
cleaning liquid.
• Never rub the nozzle surface of the heads.
• Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
IMPORTANT
When a warning beep sounds during cleaning
To prevent the print heads from drying out, an alarm sounds about 10 minutes after the start of the operation. Perform
the operation by following the message displayed in the Utility window.
IMPORTANT
Be sure to perform operations as specified by the instructions, and never touch any area not
specified in the instructions.
Sudden movement of the machine may cause injury.
WARNING
Use the following link to view a reference video for this procedure. We recommend that you view this video to under-
stand the overall flow of work.
https://youtu.be/1eLWD9uPrR0
MEMO
Procedure
1. Open the Utility window.
P. 10Opening the Utility Window/Exiting Utility
2. On the [Adjustment] tab, click [Manual Cleaning].
Manual Cleaning
Regular Maintenance 73
To Next Page
Loading...
