Setting the Dry Time
You can set the time that the printer waits from the completion of the printing and cutting of one job to
the starting of the printing and cutting of the next job.
Especially in the case of printing and cutting, it is recommended to set a time that allows the ink to be
sufficiently dried before cutting is started.
For information on the setting method, refer to [VersaWorks Help].
Note that when you set the dry time in VersaWorks, if [Use Printer Settings] is selected, the dry time is set to "0."
IMPORTANT
RELATED LINKS
・ VersaWorks Help
Utility : Other Function
54 Optimizing the Output Quality
To Next Page
Loading...
