Types of Media
In this manual, the paper used for output is called "media." The two main types of media used in this ma-
chine are shown below.
• Roll media: Media wound onto a paper tube
• Sheet media: Media not wound onto a paper tube such as standard-size media
Various paper types of roll media and sheet media are selectable according to your purpose. For detailed
information about each media, contact your media supplier. Media can also be purchased from our web-
site.
RELATED LINKS
・ https://www.rolanddg.com/
Usable Media
This machine cannot print on every kind of media. Before selecting media, be sure to perform trial print-
ing to check whether satisfactory output quality is obtained.
Size
Usable Media
Width
*1
• 150 to 170 mm (5.9 to 6.7 in.)
• 200 to 235 mm (7.9 to 9.3 in.)
• 287 to 322 mm (11.3 to 12.7 in.)
• 348 to 383 mm (13.7 to 15.1 in.)
• 393 to 429 mm (15.5 to 16.9 in.)
• 439 to 474 mm (17.3 to 18.7 in.)
• 487 to 515 mm (19.2 to 20.3 in.)
Cuttable media thickness
*1
Max. 0.22 mm (8.66 mil; depending on the media composition)
Maximum media thickness (including back-
ing paper)
*1
When only printing: 1.0 mm (39.4 mil)
When performing cutting: 0.4 mm (15 mil)
Maximum roll outer diameter 150 mm (5.9 in.)
Paper tube (core) inner diameter 76.2 mm (3 in.) or 50.8 mm (2 in.)
*1 Applies to both roll and sheet media
Maximum Roll Weight
6 kg (13.23 lb.)
Other Conditions
Media such as the following cannot be used.
• Media whose end is attached to the paper tube (core)
• Media that is severely warped or that has a strong tendency to reroll
• Media that cannot withstand the heat of the media heating system
• Media whose paper tube (core) is bent or crushed
• Media that bends under its own weight when loaded
• Media on a sagging roll
• Media that is rolled unevenly
About the Media Used
14 Basic Information
To Next Page
Loading...
