Roland VersaSTUDIO - Utility: Other Function; Performing Various Adjustments through a Sequence of Operations

Performing Various Adjustments Through a Sequence of Operations
You can perform various output adjustments through a sequence of operations by clicking [Adjust All] on
the [Adjustment] tab. The adjustment method is the same as when adjusting settings individually.
Click [Adjust All] to display the screen shown in this figure.
[Next]: Continues to the screen for the adjustment currently displayed on the screen.
[Skip]: Skips the adjustment currently displayed on the screen.
[Cancel]: Cancels the adjustment process.
The adjustments vary depending on the output method. Refer to the table below.
Printing (Only)
Cutting (Only) Printing and Cutting Crop-Cut
Check Nozzle Condition ✓ - ✓ ✓
Bidirectional adjust-
ment
*1
✓ - ✓ ✓
Calibrate Sheet Feeding ✓ ✓ ✓ ✓
Cut Adjustment - ✓ ✓ ✓
Print and Cut Adjust-
ment
- - ✓ ✓
CropCut Adjustment - - - ✓
*1 This is available when bidirectional printing is set in the BN-20D driver or VersaWorks.
RELATED LINKS
・ P. 29Printing Tests and Normal Cleaning
・ P. 27Bidirectional Adjustment
Utility : Other Function
52 Optimizing the Output Quality