Printing and Cutting Adjustment
When performing both printing and cutting, adjust and align the printing and cutting positions. Depending
on the media thickness, sometimes printing and cutting positions are very slightly out of alignment. We
recommend that you make corrections to match the media you are using.
When making these adjustments, use adhesive media that can be cut.
MEMO
Procedure
1. Load the media to be cut.
P. 20Step 1: Loading Media
2. Open the Utility window.
P. 10Opening the Utility Window/Exiting Utility
3. Click [Print and Cut Adjustment].
4. Click [Print and Cut Pattern].
A test pattern is printed.
Cutting / Printing and Cutting
Optimizing the Output Quality 43
To Next Page
Loading...
