5. Enter the [Cut Force][Cut Speed][Cut Times].
[Cut Force]
This is the force of the blade during cutting. If this force is too strong, the blade cuts into the
backing paper. (Default setting: 50 gf)
[Cut Speed]
This is the speed of the blade during cutting. If this speed is too fast, the cutting line will be
crooked. (Default setting: 15 cm/sec.)
[Cut Times]
This is the number of times to cut the same location. If cutting is not possible even after adjust-
ing the force and speed of cutting, increase the number of cuts. (Default setting: 1)
Check item Result Setting item Adjustment
Check the shape. The cut shape is distorted. [Cut Speed] Reduce
Peel off the circle.
The square also peels off. [Cut Force] Increase
Some uncut areas remain. [Cut Speed] Reduce
Peel off the square.
The blade leaves faint traces on the backing
paper.
[Cut Force]
No change
The blade trace is indistinct. Increase
The blade trace is too deep and cuts into the
backing paper.
Reduce
6. Click [Apply].
Repeatedly perform [Test Cut] and make adjustments until the appropriate adjustments are ob-
tained.
7. Click [Close].
Cutting / Printing and Cutting
Optimizing the Output Quality 41
To Next Page
Loading...
