Rosemount 3051S - Page 25

17
Reference Manual
00809-0100-4803, Rev GA
Configuration
September 2017
Configuration
Figure 2-12. Engineering Assistant Device Connection Screen
3. Select the Search button located in the lower right corner of the screen. Engineering Assistant will
begin to search for connected devices.
4. When the search is completed, select the device to communicate with and select Send
Configuration button.
5. Once the configuration is finished being sent to the device, a notification appears.
6. If finished with the configuration process, close Engineering Assistant.
Note
After the configuration is sent to the device, saving the configuration file is recommended. For more
information on saving a configuration file, see “Saving a configuration” on page 17.
Sending a configuration in online mode
1. To send the configuration, select the Send button. Once the configuration is finished being sent to
the device, a notification appears.
2. If finished with the configuration process, close Engineering Assistant.
Note
After the configuration is sent to the device, saving the configuration file is recommended. For more
information on saving a configuration file, see “Saving a configuration”.
Saving a configuration
1. To save the configuration, select the Save button.
2. Navigate to the save location for the configuration file, give the file a name, and select Save. The
configuration will be saved as a “.smv” file type.